Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Wheel Speed Sensor: Installation
- If water or oil contacts the connector terminal of front wheel speed sensor, replace it with a new part.
- If CVTF has leaked when the front wheel speed sensor is removed, adjust the CVTF level after installing the front wheel speed sensor.
- Install the front wheel speed sensor using a new O-ring.CAUTION:
- Before installing O-rings, apply sufficient amount of CVTF to avoid damage and deformation.
- Use SUBARU genuine CVTF.
- Be careful not to incorrectly install or fail to install O-rings and other such parts.
Tightening torque:
5 N.m (0.5 kgf-m, 3.7 ft-lb)
- Connect the front wheel speed sensor harness connector.
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.