Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Strut: Installation
- Install the mount strut front at the upper side of the strut assembly to the vehicle body.
Tightening torque:
32 N.m (3.3 kgf-m, 23.6 ft-lb)
- Align alignment marks on the camber adjusting bolt and the strut assembly, and install the strut assembly to the front axle housing.NOTE: While holding the bolt head of adjusting bolt, tighten the nut.
Tightening torque:
155 N.m (15.8 kgf-m, 114.3 ft-lb)
- Install the sensor sub assembly front and harness bracket.CAUTION: During the installation, make sure that the marking of sensor sub assembly front harness does not twist.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the brake hose bracket.
Tightening torque:
33 N.m (3.4 kgf-m, 24.3 ft-lb)
- Install the stabilizer link front.
Tightening torque:
60 N.m (6.1 kgf-m, 44.3 ft-lb)
- Lower the vehicle, and install the front wheels.
Tightening torque:
120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Inspect the wheel alignment and adjust if necessary.
- Inspection: Ref. to FRONT SUSPENSION>WHEEL ALIGNMENT>INSPECTION .
- Adjustment: Ref. to FRONT SUSPENSION>WHEEL ALIGNMENT>ADJUSTMENT .
- Perform the following adjustments using Subaru Select Monitor.
- Lane keep assist learning value clear: Ref. to EYESIGHT (DIAGNOSTICS)>CLEAR ACTIVE LANE KEEP SYSTEM LEARNING VALUE>OPERATION .
- VDC sensor midpoint setting mode: Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT .
NOTE: For detailed operation procedures, refer to "Help" of application.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.