Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
High-Pressure Fuel Pump
- Install the fuel pump lifter to the high-pressure fuel pump case.NOTE:
- Apply engine oil to the side of the high-pressure fuel pump case and to the bottom surface of the fuel pump lifter.
- After installing the fuel pump lifter, rotate the crankshaft in order to set the fuel pump lifter comes to the lowest position.
- Set a new O-ring, using TORX PLUSĀ®
40IP, install the high-pressure fuel pump.
Tightening torque:Ā
21 N.m (2.1 kgf-m, 15.5 ft-lb)
- Connect the connector (A) to the high-pressure fuel pump.
- Install the high-pressure fuel delivery pipe. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>HIGH PRESSURE FUEL DELIVERY PIPE>INSTALLATION>HIGH-PRESSURE FUEL DELIVERY PIPEĀ .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- ā¢ You smell fuel, burning insulation, or see smoke.
- ā¢ Brakes feel soft, pull hard to one side, or make grinding noises.
- ā¢ The engine overheats, stalls repeatedly, or misfires under load.
- ā¢ You are missing required tools, torque specs, or safe lifting equipment.
- ā¢ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.