2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Operating Cylinder: Installation

  1. Install in the reverse order of removal.
    NOTE:
    • Use a new gasket.
    • Before installing the operating cylinder, apply grease to the contact point of the release lever and operating cylinder.

      Grease:Β 

      NICHIMOLY N-130 or equivalent

    • Be sure to install the clutch hose with the mark side facing upward.
    • Be careful not to twist the clutch hose during installation.
    • STI model

      Tightening Torque:Β 

      T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

      T2: 41 N.m (4.2 kgf-m, 30.2 ft-lb)

      G05003669
      G12448525
    • Except for STI model

      Tightening Torque:Β 

      T1: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

      T2: 37 N.m (3.8 kgf-m, 27.3 ft-lb)

      G07689611
      G12448527
  2. After bleeding air from the operating cylinder, ensure that the clutch operates properly.

    Ref. to CLUTCH SYSTEM>Clutch Fluid Air BleedingΒ 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.