2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

MT Gear Select Cable: Adjustment

NOTE: Two persons are required to perform the MT gear select cable adjustment. (Only the step Β 7 requires two workers.)
  1. Move the shift lever to the 6th.
  2. Remove the cable cover plate.
    G10267862
  3. Disconnect the MT gear select cable.
    CAUTION: Do not apply extra overload while holding the part (a).
    G12392938
    NOTE: Push the MT gear select cable in the direction of arrow, and remove it.
    G12448442
  4. Measure the exposed length (a) of MT gear select cable.
    G12448443
  5. Slide the slider (green) in the direction of the arrow and release the lock piece (pink) by using flat tip screwdriver etc.
    CAUTION: Lock piece is easily damaged for the resin. When the lock piece is broken, replace the new MT gear select cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.