Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Front Strut: Removal
- Lift up the vehicle, and then remove the front wheels.
- Remove the strut assembly.
- Place an alignment mark (a) on the adjusting bolt and the strut.
- Remove the brake hose bracket.
- Remove the clamp of ABS wheel speed sensor harness.
- Remove the adjusting bolts and flange bolts for the strut assembly.CAUTION: While holding the adjusting bolt side, tighten the nut side.
- Remove the three nuts securing strut mount to body.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.