2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Throttle Sensor (Method With Circuit Tester)

  1. Disconnect the ground terminal from battery sensor. Ref. to NOTE>BATTERY .
  2. Remove the Engine Control Module (ECM). Ref. to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>Engine Control Module (ECM)>REMOVALΒ .
  3. Install the ST between the ECM and bulkhead harness and the engine wiring harness. Ref. to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>General Description>CAUTION .

    ST 18460AA030

    CHECK BOARD

  4. Connect the ground terminal to battery sensor. Ref. to NOTE>BATTERY .
  5. After warming-up the engine, turn the ignition switch to OFF.
  6. Turn the ignition switch to ON. (Engine OFF)
  7. Measure the voltage between ECM connector terminals using ST.
    G12444049
    THROTTLE SENSOR ACCELERATOR PEDAL TERMINAL NO. STANDARD
    Main Not depressed (full closed) 17 (+) and 30 (-) Approx. 0.7 V
    Depressed (full opened) Approx. 3.9 V
    Sub Not depressed (full closed) 29 (+) and 30 (-) Approx. 4.4 V
    Depressed (full opened) Approx. 1.1 V
  8. After inspection, install the related parts in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.