2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Remove the collector cover. Ref. to INTAKE (INDUCTION) (EXCEPT FOR STI)>Collector Cover>REMOVAL .
  2. Disconnect the ground terminal from battery sensor. Ref. to NOTE>BATTERY .
  3. Remove the intercooler. Ref. to INTAKE (INDUCTION) (EXCEPT FOR STI)>Intercooler>REMOVAL .
  4. Remove the throttle body. Ref. to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>Throttle Body>REMOVALΒ .
  5. Remove the bolts securing the engine wiring harness.
    G10266205
  6. Disconnect the connector (A) from the knock sensor, and remove the knock sensor from the cylinder block.
    G09479753
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.