2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Intake Side

  1. Disconnect the ground terminal from battery sensor. Ref. to NOTE>BATTERY .
  2. Remove the air intake duct. (RH side only) Ref. to INTAKE (INDUCTION) (EXCEPT FOR STI)>Air Intake Duct>REMOVAL .
  3. Disconnect the connector (A) from the camshaft position sensor, and remove the camshaft position sensor from the chain cover.
    • RH side
      G11264982
    • LH side
      G09479737
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.