Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Basic Diagnostic Procedure: Procedure
- PERFORM CUSTOMER INTERVIEW
.
Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Ref. to COMBINATION METER (DIAGNOSTICS)>Check List for Interview>CHECK .
Did you interview the customer?
Yes Go to 2 .
No Interview the customer. Ref. to COMBINATION METER (DIAGNOSTICS)>Check List for Interview>CHECK .
- CHECK CAN COMMUNICATION
.
Read the DTC of the CAN system using the Subaru Select Monitor. Ref. to LAN SYSTEM (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC)>OPERATION .
Are any DTCs displayed?
Yes Perform the diagnosis for the displayed DTCs. Ref. to LAN SYSTEM (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC)>LIST .
No Go to 3 .
- CHECK COMBINATION METER
.
Using the Subaru Select Monitor, read DTC of combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>Read Diagnostic Trouble Code (DTC) .
Are any DTCs displayed?
Yes Record the DTCs and time stamps, and perform the diagnosis for the displayed DTCs. Ref. to BODY CONTROL SYSTEM (DIAGNOSTICS)>List of Diagnostic Trouble Code (DTC)>LIST .
For time stamp, refer to "LAN SYSTEM". Ref. to LAN SYSTEM (DIAGNOSTICS)>General Description>CAUTION>TIME STAMP .
Go to 5.
No Go to 4 .
- CHECK COMBINATION METER
.
Check the operation of combination meter. Ref. to COMBINATION METER (DIAGNOSTICS)>System Operation Check Mode .
Is the check result OK?
Yes System is normal.
No Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>Combination Meter .
- PERFORM DIAGNOSIS
.
- Perform the Clear Memory Mode.
- Perform the Inspection Mode. Ref. to COMBINATION METER (DIAGNOSTICS)>Inspection Mode .
- Using the Subaru Select Monitor, read DTC of combination meter.
Are any DTCs displayed?
Yes Perform the diagnosis for the displayed DTCs.
No Finish the diagnosis.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
