Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
VDC Sequence Control With SUBARU Select Monitor
NOTE:
In the event of any trouble, sequence control will not operate.
- Connect the Subaru Select Monitor.NOTE: For detailed operation procedures, refer to "Application Help".
- Turn the ignition switch to ON.
- On «Start» display, select «Diagnosis».
- On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
- On «Main Menu» display, select «Each System».
- On «Select System» display, select «Brake Control System» and select «Enter».
- On «Select Function» display, select «Work Support».
- From the work support item list, select «VDC Function Check Mode».
- Operate according to the procedures displayed in the Subaru Select Monitor.
- The brake system being operated is displayed on the Subaru Select Monitor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.