Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
VDC Control Module And Hydraulic Control Unit (VDC CONTROL MODULE & H/U): Removal
CAUTION:
- Avoid unnecessary removal of parts in order to prevent fluid leakage.
- When the VDC CONTROL MODULE & H/U components are removed, be sure to perform the installation according to the installation procedures. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module And Hydraulic Control Unit (VDC CONTROL MODULE & H/U)>INSTALLATIONΒ .
- Disconnect the ground cable from battery. Ref. to NOTE>NOTE>BATTERY
.NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
- Remove the engine control module (ECM). (Except for STI model) Ref. to FUEL INJECTION (FUEL SYSTEMS) (EXCEPT FOR STI)>Engine Control Module (ECM)>REMOVAL .
- Remove the VDC control module & hydraulic control unit (VDC CONTROL MODULE & H/U).CAUTION:
- Do not pull on the harness when disconnecting the connector.
- Wrap the brake pipe with a vinyl bag so as not to spill the brake fluid on the painted surface of the vehicle body.
- If brake fluid is spilled on the painted surface of the vehicle body, wash it off immediately with water and wipe clean.
- Remove any dirt from around the VDC CONTROL MODULE & H/U.
- Remove the nuts, and remove the bracket (a) from the bracket - connector front. (Except for STI model)
- Pull up the lock lever (b) while pressing the lock button (a) and disconnect the VDC CONTROL MODULE & H/U connector.
- Separate each brake pipe using a flare nut wrench.
- Remove the bolts, and remove the bracket (a) and hose (b) from the bracket - hydraulic unit. (Models with Eye-Sight)
- Remove the bolts and nuts, and remove the bracket - hydraulic unit and the VDC CONTROL MODULE & H/U.
- Remove the bolts, and remove the VDC CONTROL MODULE & H/U (a) from the bracket - hydraulic unit (b).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
