Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Front ABS Wheel Speed Sensor: Installation
CAUTION:
- Be careful not to damage the sensor.
- Do not apply excessive force to the sensor harness.
- Install the front ABS wheel speed sensor.
Tightening Torque:
Front ABS wheel speed sensor: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Front ABS wheel speed sensor bracket: 33 N.m (3.4 kgf-m, 24.3 ft-lb)
- Install the front wheels.
Tightening Torque:
Front wheel: 120 N.m (12.2 kgf-m, 88.5 ft-lb)
- Lower the vehicle.NOTE: Check if the harness is not pulled and does not come in contact with the suspension or body while operating the steering.
- Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.