2018 Subaru Forester 2.0XT PremiumFACTORY OEM SERVICE PROCEDURE

Drive Cycle X

DTC Item Condition Number of driving cycles on the detecting condition
P2004 TGV CONTROL STUCK OPEN BANK 1 - 1
P2005 TGV CONTROL STUCK OPEN BANK 2 - 1
P2006 TGV CONTROL STUCK CLOSED BANK 1 - 1
P2007 TGV CONTROL STUCK CLOSED BANK 2 - 1

Diagnostic procedure:Β 

  1. Idle the engine for 10 seconds or more after engine start.
  2. Shift the select lever to "P" range, and let the engine race for 10 seconds or more.
    NOTE: Keep Engine speed at 3500 rpm or more.
  3. Read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Read Diagnostic Trouble Code (DTC)>OPERATIONΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.