2018 Subaru Forester 2.0XT PremiumFACTORY OEM SERVICE PROCEDURE

Drive Cycle S

DTC Item Condition Number of driving cycles on the detecting condition
P0246 TURBOCHARGER/SUPERCHARGER WASTEGATE SOLENOID "A" HIGH - 1
P04AD EVAP SYSTEM (CPC) PURGE CONTROL VALVE "B" CIRCUIT HIGH - 2
WARNING: When performing the drive cycle S on the public road, be very careful of the traffic condition and the safe driving must be the high priority.

Diagnostic procedure:Β 

  1. Drive 3 times according to the drive pattern described below.
    G12519108Courtesy of SUBARU OF AMERICA, INC.
  2. Read the temporary code using the Subaru Select Monitor or general scan tool. Ref. to ENGINE (DIAGNOSTICS) (H4DOTC)>Read Diagnostic Trouble Code (DTC)>OPERATIONΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.