Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Active Test: Operation: Engine
WARNING: This page is about a different variant/trim than selected.
NOTE:
For detailed operation procedures, refer to "Application help".
| Active test items | Contents | Execution condition |
|---|---|---|
| Fuel Pump Control (ON/OFF Dr.) | ON/OFF of the fuel pump can be set. | Ignition switch is ON (engine OFF) |
| CPC Solenoid Valve | ON/OFF of the purge control solenoid valve can be set. | |
| Radiator Fan Relay | ON/OFF of the radiator fan relay can be set. | |
| A/C Compressor Relay | ON/OFF of the A/C relay can be set. | |
| Turbocharger Wastegate Solenoid | Wastegate control solenoid valve can be set between 0.0% ←→ 99.6%. | |
| CPC Solenoid 2 | ON/OFF of the purge control solenoid valve 2 can be set. | |
| ELCM switching valve | ON/OFF of the leak check valve assembly switching valve can be set. | |
| ELCM pump | ON/OFF of the leak check valve assembly vacuum pump can be set. | |
| Fuel Pump Control (OFF Drive) | Fuel pump can be set to OFF. | At idling |
| Fixed Idle Ignition Timing | Idle ignition timing can be set and fixed to 10.0°. | |
| Idle Speed Control | Idle speed can be set to 500 - 2000 rpm. | |
| Injection Stop Mode (Injector 1) Injection Stop Mode (Injector 2) Injection Stop Mode (Injector 3) Injection Stop Mode (Injector 4) |
Injector of each cylinder can be set to stop the fuel injection. | |
| Injection Quantity Control | The amount of fuel injection can be set to 0 - 20%. | |
| EGR Valve Control | EGR control valve can be set to 0 - 255 STEP. | |
| High Pressure Fuel Inspection | High pressure fuel pipe inspection can be executed. | |
| Alternator control | Alternator control mode can be set to one of the followings: Low mode Middle mode High mode ExHigh mode | |
| Compression monitor | Compression can be measured. |
|
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.