Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection Mode 1
| DTC | Description & trouble part | Note |
|---|---|---|
| B1010 | BODY CONTROL SYSTEM (BIU) MALFUNCTION | - |
| B1011 | BATTERY CONTROL POWER SUPPLY | - |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [Body Control]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY
- Using the Subaru Select Monitor, read the DTC of [Body Control] to check that there is no DTC displayed. Ref. to BODY CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) NOTE:
If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1 .
- Disconnect the ground terminal from the battery sensor, reconnect it, and then wait for one minute or more.
- Using the Subaru Select Monitor, read the DTC of [Body Control] to check that there is no DTC displayed. Ref. to BODY CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) NOTE:
If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.