2017 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

DTC P050A Cold Start Idle Control System Performance: Notes

DTC DETECTING CONDITION:Β 

Detected when two consecutive driving cycles with fault occur.

TROUBLE SYMPTOM:Β 

  • Engine keeps running at higher speed than specified idle speed.
  • Engine keeps running at a lower speed than the specified idle speed.
  • Engine stalls.
    CAUTION:
    • After servicing or replacing faulty parts, perform Clear Memory Mode <Ref. to OPERATION , Clear Memory Mode.>, and Inspection Mode <Ref. to PROCEDURE , Inspection Mode.>.
    • Use the check board when measuring the ECM terminal voltage and resistance.

WIRING DIAGRAM:Β 

Engine Electrical System <Ref. to WIRING DIAGRAM , Engine Electrical System.>

Fig 1: System Too Rich Bank 1 Wiring Diagram
G11577041Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.