Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Main Switch
CAUTION:
- After installing the switch - power window main, always perform the initial setting.
Failure to do so may cause the improper activation of auto-reverse operation for pinching hazard prevention.
- Use protective paper to avoid damage to the trim panel.
- Install the panel - power window main switch to the trim panel - front door.
- Install the trim panel - front door. <Ref. to INSTALLATION , Door Trim.>
- Connect the battery ground terminal. <Ref. to BATTERY , NOTE, Note.>
- Perform initial setting operation (reset operation A). <Ref. to RESET OPERATION A , OPERATION, Power Window System.>
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.