Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Auto Headlight Beam Leveler Control Module
| Contents | Terminal No. | Measuring condition | Standard |
|---|---|---|---|
| IG power supply | 1 β Chassis ground | Ignition switch ON | 8 - 16 V |
| GND | 2 β Chassis ground | Always | Less than 1 Ξ© |
| Rr vehicle height sensor GND | 3 β Chassis ground | Always | Less than 1 Ξ© |
| RH headlight malfunction signal | 5 β Chassis ground | Always | 1 MΞ© or more |
| Leveling actuator power supply | 10 β Chassis ground | Ignition switch ON | 10 - 16 V |
| Leveling actuator GND | 11 β Chassis ground | Always | Less than 1 Ξ© |
| Rr vehicle height sensor power supply | 12 β 3 | Ignition switch ON | 4.75 - 5.25 V |
| LH headlight malfunction signal | 16 β Chassis ground | Always | 1 MΞ© or more |
| Leveling actuator signal | 17 β Chassis ground | Headlight off β on | Less than 1 V β 1.0 - 14.4 V (for 17 seconds) |
| Headlight on, no vehicle height change β change and hold vehicle height for 3 seconds or more | |||
| Rr sensor signal | 19 β Chassis ground | IG ON (with no passenger, no load and vehicle stopped) | Approx. 2.5 V (changes according to vehicle condition) |
| CAN-H | 23 | Cannot be measured (CAN communication line) | - |
| CAN-L | 24 | Cannot be measured (CAN communication line) | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
