2017 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE

Malfunction Indicator Light: Procedure

WARNING: This page is about a different variant/trim than selected.
1. Activation of malfunction indicator light Ref. to ACTIVATION OF MALFUNCTION INDICATOR LIGHT , Malfunction Indicator Light.
↓
2. Malfunction indicator light does not come on Ref. to MALFUNCTION INDICATOR LIGHT DOES NOT COME ON , Malfunction Indicator Light.
↓
3. Malfunction indicator light does not go off Ref. to MALFUNCTION INDICATOR LIGHT DOES NOT GO OFF , Malfunction Indicator Light.
↓
4. Malfunction indicator light does not blink Ref. to MALFUNCTION INDICATOR LIGHT DOES NOT BLINK , Malfunction Indicator Light.
↓
5. Malfunction indicator light remains blinking Ref. to MALFUNCTION INDICATOR LIGHT REMAINS BLINKING , Malfunction Indicator Light.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.