2017 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE

Air Intake Boot: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the air intake boot and connect the blow-by hose (D) to the air intake boot.
  2. Tighten the clamp (B) securing the throttle body to the air intake boot.
  3. Tighten the bolt (C) securing the air intake boot to the collector cover bracket.
  4. Tighten the clamp (A) securing the air cleaner case (rear) to the air intake boot.

    Tightening torque:Β 

    T1: 3 N.m (0.3 kgf-m, 2.2 ft-lb)Β 

    T2: 6.5 N.m (0.7 kgf-m, 4.8 ft-lb)Β 

    Fig 1: Connecting Blow-By Hose To Air Intake Boot
    G11585939Courtesy of SUBARU OF AMERICA, INC.
  5. Install the collector cover.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.