2017 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE

Immobilizer Control Module

Detecting condition: 

  • Defective harness
  • Power supply circuit malfunction
  • Defective immobilizer control module
  • Body integrated unit malfunctioning
  • Defective CAN communication circuit
  • Defective Subaru Select Monitor

Trouble symptom: 

Not communicable with Subaru Select Monitor.

Wiring diagram: 

NOTE: For the coupling connector, refer to "WIRING SYSTEM".

Immobilizer system Ref. to WIRING DIAGRAM , Immobilizer System. i34

Fig 1: Immobilizer Control Module Wiring Diagram
G10273212Courtesy of SUBARU OF AMERICA, INC.
Step Check Yes No
1 CHECK FUSE. 
Check the fuse.
Is the check result OK? Go to step 2  Replace the fuse. If the replaced fuse blows out easily, repair the ground short circuit in the harness between the battery and immobilizer control module.
2 CHECK LAN SYSTEM. 
Inspect LAN system. Ref. to BASIC DIAGNOSTIC PROCEDURE .
Is the check result OK? Go to step 3  . Perform the inspection according to the diagnosis for LAN system.
3 CHECK HARNESS. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the immobilizer control module connector.
  3. Turn the ignition switch to ON.
  4. Using a tester, measure the voltage between the immobilizer control module connector and chassis ground.

    Connector & terminal 

    (i34) No. 2 (+) - Chassis ground (-): 

    (i34) No. 1 (+) - Chassis ground (-): 

Is the voltage 10 - 13 V? Go to step 4  Repair the open circuit of harness between the immobilizer control module connector and fuse.
4 CHECK HARNESS. 
Using a tester, measure the resistance between the immobilizer control module connector and chassis ground.
Connector & terminal 
(i34) No. 16 - Chassis ground: 
Is the resistance less than 1 Ω? Go to step 5  Repair the open circuit of harness between the immobilizer control module connector and chassis ground.
5 CHECK IMMOBILIZER CONTROL MODULE. 
  1. Turn the ignition switch to OFF.
  2. Connect the immobilizer control module connector.
  3. Perform communication with the immobilizer control module.
Is communication possible? The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis.
NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
Replace the immobilizer control module. Ref. to IMMOBILIZER CONTROL MODULE
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.