2017 Subaru Legacy 2.5iFACTORY OEM SERVICE PROCEDURE

Select Cable: Installation

  1. Position the select cable as shown in the figure, and install it to the plate assembly.
    CAUTION:
    • If the cable is installed in the wrong direction, loosen the bracket bolts, and then reinstall the cable in the correct direction.
    • Do not adjust the cable end direction by turning it forcibly to prevent the boot from being twisted.

    Tightening torque: 

    T: 18 N.m (1.8 kgf-m, 13.3 ft-lb) 

    Fig 1: Cable And Plate Assembly Bolts
    G11564575Courtesy of SUBARU OF AMERICA, INC.
  2. Install the select cable to the shifter arm.
  3. Install the plate assembly.

    Tightening torque: 

    T: 25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    Fig 2: Plate Assembly Bolts
    G11564576Courtesy of SUBARU OF AMERICA, INC.
  4. Install the washer and snap pin to the shifter arm.
    Fig 3: Identifying Shifter Arm, Snap Pin, Select Cable And Plate Assembly
    G11564577Courtesy of SUBARU OF AMERICA, INC.
  5. Install new clamp paying attention to the installing direction.
    Fig 4: Installing Clamp
    G11564578Courtesy of SUBARU OF AMERICA, INC.
  6. Insert the cable socket into the bracket and the connector in the arrow direction from the side to assemble the cable.
    Fig 5: Inserting Cable Socket Into Bracket And Connector
    G11564579Courtesy of SUBARU OF AMERICA, INC.
  7. Shift the select lever to the "N" range, and then adjust the select cable position. <Ref. to ADJUSTMENT , Select Cable.>
  8. Install the center exhaust cover.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb) 

  9. Install the center exhaust pipe. (2.5 L model) <Ref. to INSTALLATION , Center Exhaust Pipe.>
  10. Install the front exhaust pipe and rear exhaust pipe. (3.6 L model) <Ref. to INSTALLATION , Front Exhaust Pipe.> <Ref. to INSTALLATION , Rear Exhaust Pipe.>
  11. Connect the ground terminal to battery sensor. <Ref. to BATTERY , NOTE, Repair Contents.>
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.