Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru Forester 2.0XT PremiumFACTORY OEM SERVICE PROCEDURE
Select Lever: Installation
- Set the select lever assembly to the vehicle body.
- Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Connect the harness connector.
- Install the harness clip to the select lever assembly.
- Shift the select lever to "N" range.
- Install the blind A to the housing. (Model with gate shifter)NOTE: The blind A should be installed so that it is securely caught inside the tab of the housing.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.