2017 Subaru Forester 2.0XT PremiumFACTORY OEM SERVICE PROCEDURE

Occupant Detection System DTCS

OCCUPANT DETECTION SYSTEM DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC Item Content of diagnosis Reference
B1650 OCCUPANT DETECTION SYSTEM MALFUNCTION
  • Occupant detection sensor is faulty.
  • Occupant detection control module is faulty.
  • Occupant detection harness is faulty.
  • Fuse No. 25 is blown out.
  • Rear airbag harness is faulty.
Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B1650 OCCUPANT DETECTION SYSTEM MALFUNCTION .
B1655 FRONT BUCKLE SWITCH RH FAILURE
  • Passenger's buckle switch circuit is open, shorted or shorted to ground.
  • Occupant detection system is faulty.
  • Occupant detection harness is faulty.
Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B1655 FRONT BUCKLE SWITCH RH FAILURE .
B1760 OCCUPANT DETECTION SENSOR MAT
  • Occupant detection sensor is faulty.
  • Occupant detection sensor circuit is open, shorted between terminals, shorted to power supply or shorted to ground.
  • Seat heater circuit is open.
  • Occupant detection control module is faulty.
Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B1760 OCCUPANT DETECTION SENSOR MAT .
B1771 BUCKLE SWITCH
  • Passenger's seat buckle switch is faulty.
  • Passenger's buckle switch circuit is open, shorted or shorted to ground.
  • Occupant detection system is faulty.
  • Occupant detection harness is faulty.
Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B1771 BUCKLE SWITCH .
B1795 OCCUPANT DETECTION MODULE INTERNAL CIRCUIT Occupant detection control module is faulty. Ref. to OCCUPANT DETECTION (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC B1795 OCCUPANT DETECTION MODULE INTERNAL CIRCUIT .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.