Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2017 Subaru Crosstrek BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Installation

WARNING: This page is about a different variant/trim than selected.

Set the select lever assembly to the vehicle body.
Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Locating Select Lever Assembly To Vehicle Body Mounting Bolts
Courtesy of SUBARU OF AMERICA, INC.
Connect the harness connector.

Fig 2: Harness Connector Location
Courtesy of SUBARU OF AMERICA, INC.
Install the harness clip to the select lever assembly.

Fig 3: Locating Select Lever Assembly Harness Clip
Courtesy of SUBARU OF AMERICA, INC.
Shift the select lever to "N" range.
Install the indicator assembly, then connect the connector. (Model with boot shifter)
NOTE: Insert the select lever through the blind hole sufficiently.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.