Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru Crosstrek BaseFACTORY OEM SERVICE PROCEDURE
Drive Cycle B
| DTC | Item | Condition |
|---|---|---|
| *P0125 | INSUFFICIENT COOLANT TEMPERATURE FOR CLOSED LOOP FUEL CONTROL | «Coolant Temp.» at engine start: Less than -15°C (5°F) |
| P0137 | O2 SENSOR CIRCUIT LOW VOLTAGE BANK 1 SENSOR 2 | - |
| P0138 | O2 SENSOR CIRCUIT HIGH VOLTAGE BANK 1 SENSOR 2 | - |
| *P0171 | SYSTEM TOO LEAN BANK 1 | Complete diagnosis with drive cycle A or C as well. |
| *P0172 | SYSTEM TOO RICH BANK 1 | Complete diagnosis with drive cycle A or C as well. |
| *P0300 | RANDOM/MULTIPLE CYLINDER MISFIRE DETECTED | Complete diagnosis with drive cycle A or C as well. |
| *P0301 | CYLINDER 1 MISFIRE DETECTED | Complete diagnosis with drive cycle A or C as well. |
| *P0302 | CYLINDER 2 MISFIRE DETECTED | Complete diagnosis with drive cycle A or C as well. |
| *P0303 | CYLINDER 3 MISFIRE DETECTED | Complete diagnosis with drive cycle A or C as well. |
| *P0304 | CYLINDER 4 MISFIRE DETECTED | Complete diagnosis with drive cycle A or C as well. |
| P0500 | VEHICLE SPEED SENSOR "A" CIRCUIT | - |
| *P0506 | IDLE CONTROL SYSTEM RPM - LOWER THAN EXPECTED | - |
| *P0507 | IDLE CONTROL SYSTEM RPM - HIGHER THAN EXPECTED | - |
| P0700 | TRANSMISSION CONTROL SYSTEM (MIL REQUEST) | - |
| *P2096 | POST CATALYST FUEL TRIM SYSTEM TOO LEAN BANK 1 | Complete diagnosis with drive cycle A or C as well. |
| *P2097 | POST CATALYST FUEL TRIM SYSTEM TOO RICH BANK 1 | Complete diagnosis with drive cycle A or C as well. |
Diagnostic procedure:
- Drive at 10 km/h (6 MPH) or more.
- Stop the vehicle and idle for ten minutes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.