2017 Subaru Crosstrek BaseFACTORY OEM SERVICE PROCEDURE

Communication For Initializing Impossible

DIAGNOSIS: 

Open or short circuit in data link connector

TROUBLE SYMPTOM: 

Subaru Select Monitor communication failure

WIRING DIAGRAM: 

Engine electrical system Ref. to Engine Electrical System .

Fig 1: Communication For Initializing Impossible - Wiring Diagram
G10320264Courtesy of SUBARU OF AMERICA, INC.
Step Check Yes No
1 CHECK POWER SUPPLY CIRCUIT. 
Connect DST-i or general scan tool to data link connector.		 Does DST-i or the general scan tool turn ON? Go to step 4  . Go to step 2  .
2 CHECK POWER SUPPLY CIRCUIT. 
Measure the voltage between data link connector and chassis ground.
Connector & terminal 
(B40) No. 16 (+) - Chassis ground (-): 		 Is the voltage 10 V or more? Go to step 3  . Repair the power supply circuit.
NOTE: In this case, repair the following item:
  • Open or ground short circuit of harness between battery and data link connector
  • Blown out of fuse (M/B No. 13)
3 CHECK HARNESS BETWEEN DATA LINK CONNECTOR AND CHASSIS GROUND. 
  1. Turn the ignition switch to OFF.
  2. Measure the resistance of harness between data link connector and chassis ground.

    Connector & terminal 

    (B40) No. 4 - Chassis ground: 

    (B40) No. 5 - Chassis ground: 

 Is the resistance less than 5 Ω? Repair the poor contact of data link connector. Repair the harness and connector.
NOTE: In this case, repair the following item:
  • Open circuit in harness between ECM connector and data link connector
  • Open circuit of harness between ECM connector and engine ground
  • Poor contact of ECM connector
  • Poor contact of coupling connector
4 CHECK HARNESS BETWEEN ECM AND DATA LINK CONNECTOR. 
Measure the resistance between data link connector and chassis ground.
Connector & terminal 
(B40) No. 7 - Chassis ground: 		 Is the resistance 1 MΩ or more? Repair the poor contact of the ECM or data link connector. Repair the short circuit to ground in harness between ECM connector and data link connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.