2017 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE

Charging System DTCS

CHARGING SYSTEM DIAGNOSTIC TROUBLE CODE IDENTIFICATION

Diagnostic codes Diagnostic items Reference
P0562 [System Voltage Low] DTC P0562 System Voltage Low
P0563 [System Voltage High] DTC P0563 System Voltage High
P065A [Generator/Alternator System Performance] DTC P065A Generator/alternator system performance
P0A3B [Generator/Alternator Over Temperature] DTC P0A3B Generator/alternator overheating
P1C00 [Battery Monitor Module "A" Performance] DTC P0A3B Generator/alternator overheating
U0077 [LIN Communication Bus "ECM/PCM" Off] DTC U0077 LIN communication bus "ECMPCM" off
U1712 [Lost LIN Communication With Battery "1" Monitor Module] DTC U1712 Lost LIN communication with battery "1" monitor module
U171F [Lost LIN Communication With Generator] DTC U171F Lost LIN communication with generator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.