Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
EFI system (FA20): Notes
| DTC | Fail safe operation | Fail safe mode cancel condition |
|---|---|---|
| P062D |
|
Clear the DTC. |
| P0201 P0202 P0203 P0204 P1261 P1262 P1263 P1264 |
|
After restored to normal condition, turn IG ON. |
| P062F P0122 P0123 P0222 P0223 P0604 P0605 P0606 P060A P060B P1160 P2101 P2102 P2103 P2109 P2119 P2135 |
Electronic throttle control is prohibited and throttle opening angle is fixed. | After restored to normal condition, turn IG ON. |
| P0327 P0328 P0332 P0333 |
Ignition timing is retarded maximum level | Restoration to normal condition |
| P0451 | Leak detection pump control is prohibited. | Restoration to normal condition |
| P2158 | Vehicle speed identified by ECM is fixed at 10km/h {6.2 MPH}. | Restoration to normal condition |
| P0851 P0852 |
Gear position indicator in the combination meter is turned off (for MT models). | Restoration to normal condition |
| P1451 P2404 |
Atmospheric pressure is fixed at 101.3 kPa {760 mmHg}. | Restoration to normal condition |
| P2122 P2123 P2127 P2128 |
Normal accelerator pedal position sensor is used alternatively until the specified angle is reached. | After restored to normal condition, turn IG ON. |
| P2138 |
|
After restored to normal condition, turn IG ON. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.