Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel pressure sensor (FA20): Installation
- Fuel injector ASSY installation (Refer to
Installation )CAUTION: Use a new fuel delivery pipe (bank 1 side).
- Fuel delivery pipe (bank 1 side) and fuel pressure sensor installation
- Install the fuel delivery pipe (bank 1 side) with the two bolts.
Standard value: T=19N.m {194kgf.cm} {14.0ft.lbf}
- Temporarily install a new fuel pressure sensor to the fuel delivery pipe (bank 1 side) until it can be turned by hand.
- Fuel the fuel pressure sensor.
Standard value: T=46N.m {469kgf.cm} {33.9ft.lbf}
CAUTION:- There must be no oil on the threaded portions of fuel pressure sensor and fuel delivery pipe (bank 1 side).
- Do not allow foreign matter to get in when installing the fuel pressure sensor.
- Do not retighten (or recheck the tightening torque of) the fuel pressure sensor after it is tightened once.
- Connect the two fuel injector connectors and fuel pressure sensor connector.
- Install the fuel delivery pipe (bank 1 side) with the two bolts.
- Fuel delivery pipe installation
- Temporarily tighten the nut for the new fuel delivery pipe until it is seated.
- Temporarily install the fuel delivery pipe with the three bolts.
- Tighten the three bolts.
Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}
- Tighten the fuel delivery pipe.
Standard value: T=25N.m {255kgf.cm} {18.4ft.lbf}
- Intake manifold installation
(Refer to INSTALLATION )
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.