Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Charging Systems
- Charging system (FA20)
- Precautions
- Parts location
- On-vehicle inspection
- List of diagnostic codes
- Symptom table
- How to troubleshoot
- Checking/clearing diagnostic codes
- Circuit figure
- ECM terminal arrangement
- Data monitor/active test
- Failsafe list
- DTC P0562 System Voltage Low
- DTC P0563 System Voltage High
- DTC P065A Generator/alternator system performance
- DTC P0A3B Generator/alternator overheating
- DTC P1C00 Battery monitor module "A" performance
- DTC U0077 LIN communication bus "ECMPCM" off
- DTC U1712 Lost LIN communication with battery "1" monitor module
- DTC U171F Lost LIN communication with generator
- Alternator (FA20)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
