Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru WRX STIFACTORY OEM SERVICE PROCEDURE
VDC Control Module & Hydraulic Control Unit (VDCCM&H/U)
- Models without EyeSightFig 1: Identifying VDC Control Module & Hydraulic Control Unit Related Component With Torque Specification - Models Without EyeSight
Courtesy of SUBARU OF AMERICA, INC.
Tightening torque: N.m (kgf-m, ft-lb)
T1: 7.5 (0.8, 5.5)
T2: 15(1.5, 11.1)
T3: 19 (1.9, 14.0)
T4: 33(3.4, 24.3)
- Models with EyeSightFig 2: Identifying VDC Control Module & Hydraulic Control Unit Related Component With Torque Specification - Models With EyeSight
Courtesy of SUBARU OF AMERICA, INC.
Tightening torque: N.m (kgf-m, ft-lb)
T1: 7.5 (0.8, 5.5)
T2: 15(1.5, 11.1)
T3: 19 (1.9, 14.0)
T4: 33(3.4, 24.3)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
