Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Operating Cylinder: Assembly
NOTE:
During assembly, apply hydraulic oil to all parts.
Recommended brake fluid:
New FMVSS No. 116 DOT3 or DOT4
- Install the piston spring onto the piston.
- Insert piston into the operating cylinder.
- Install push rod to the boot.
- Install boot and push rod to the operating cylinder.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.