Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Column: Installation
- When removing, installing or replacing the VDCCM&H/U, VDCCM&H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform "VDC sensor midpoint setting mode" of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). >
- Before performing service on the airbag module, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM" section. < Ref. to CAUTION , General Description. >
- Install the bushing to the toe board.
- Insert the end of the column assembly - steering into the toe board bushing.
- Tighten the column assembly - steering installation nut located under the beam COMPL - steering with the tilt lever fixed.
Tightening torque:
20 N.m (2.0 kgf-m, 14.8 ft-lb)
- Install the ignition key lock. < Ref. to REPLACEMENT , Ignition Key Lock. >
- Install the switch assembly - combination.
- Connect all the connectors under the instrument panel.
- Install the universal joint assembly - steering. < Ref. to
INSTALLATION , Universal Joint. >CAUTION:
- Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
- Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.
- Install the knee airbag module. < Ref. to INSTALLATION , Knee Airbag Module. >
- Install the cover assembly - instrument panel LWR driver.
- Install the cover assembly - column.
- Align the center position of the steering roll connector. < Ref. to ADJUSTMENT , Roll Connector. >
- Install the steering wheel.
Tightening torque:
Steering wheel: 39 N.m (4.0 kgf-m, 28.8 ft-lb)
Clearance:
Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
- Install the driver's airbag module. < Ref. to INSTALLATION , Driver's Airbag Module. >
- Connect the battery ground terminal. < Ref. to
BATTERY
, NOTE, Note. >NOTE: For models other than STI model, connect the ground terminal to battery sensor.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.