2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Reprogramming For Vehicle Information Registration Menu Display (07-100-15)

Publication date: 2015-11-10
Reference number: 07-100-15

REPROGRAMMING FOR VEHICLE INFORMATION REGISTRATION MENU DISPLAY

REPROGRAMMING FOR VEHICLE INFORMATION REGISTRATION MENU DISPLAY

TECHNICAL SERVICE BULLETIN

Reference Number(s): 07-100-15, Date of Issue:  November 10, 2015
SUBARU: 2016 WRX

APPLICABILITY

2016MY WRX Models with EyeSight

INTRODUCTION

This bulletin announces the availability of reprogramming files for the EyeSight system to provide proper function of the Vehicle Information Registration menu. In rare cases, when attempting to perform the Camera Initialization procedure after repair or replacement, it cannot be completed because the required Vehicle information Registration menu cannot be displayed.

PRODUCTION CHANGE INFORMATION

The new logic was incorporated into production June 18, 2015 on VIN G*808423. 

PACK FILE APPLICABILITY

MODEL YEAR/MODEL NEW PART NUMBER PAK FILE NAME OLD PART NUMBERS TARGET CONTROL SOFTWARE VERSION DECRYPTION KEYWORD NEW CONTROL SOFTWARE VERSION
2016MY WRX 2.0L Turbo 87501VA013 87501VA013.pak 87501VA011, 012 00006393 762E7C42 000063B1

SERVICE PROCEDURE / INFORMATION

  • Connect the SSMIV / DST-i and follow the steps as shown in the screen shots shown below:
    G10133389
    G10133390
    G10133391
    G10133392
    G10133393
    G10133394
    G10133395
  • After installation of the proper reprogramming file(s) is complete, go back to Step 1  , proceed through to Step 5  and confirm after clicking on "Utility", both the Selection of Parameter and Confirm on Parameter appear under Work Support.
  • After confirmation, proceed to Step 6  and Step 7  to verify the Control Software Version has been updated successfully (000063B1)  to complete the procedure.

WARRANTY / CLAIM INFORMATION

For vehicles within the Basic New Car Limited Warranty period or covered by a Subaru Added Security Gold plan, this repair may be submitted using the following claim information:

LABOR DESCRIPTION LABOR OPERATION # FAIL CODE LABOR TIME
EYESIGHT SYSTEM REPROGRAMMING A067-728 ZQW-48 0.4

IMPORTANT REMINDERS: 

  • SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.
  • Always check for any open recalls or campaigns anytime a vehicle is in for servicing.
  • Always refer to STIS for the latest service information before performing any repairs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.