2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

TCM Reprogramming File Availability To Address Inconsistent Shifting/Slipping Concerns When Cold (16-98-16R)

Publication date: 2017-02-02
Reference number: 16-98-16R
Supersedes refnos: 16-98-16

TCM REPROGRAMMING FILE AVAILABILITY TO ADDRESS INCONSISTENT SHIFTING/SLIPPING CONCERNS WHEN COLD

TCM REPROGRAMMING FILE AVAILABILITY TO ADDRESS INCONSISTENT SHIFTING/SLIPPING CONCERNS WHEN COLD

TECHNICAL SERVICE BULLETIN

Reference Number(s): 16-98-16R, Date of Issue:  February 2, 2017
SUBARU: 2015-2016 WRX
Superceded Bulletin(s): 16-98-16, Date of Issue:  February 05, 2016

APPLICABILITY

2015-2016MY WRX Models

INTRODUCTION

This bulletin announces availability of reprogramming files for optimization of the transmission control module (TCM). The new logic addresses customer concerns of inconsistent shifting characteristics and/or a "slipping" -type sensation which may be experienced under moderate acceleration after a cold start before the CVT is up to operating temperature.

PRODUCTION CHANGE INFORMATION

The new TCM logic was incorporated into production starting with VIN G*825251  .

PACK FILE APPLICABILITY

MODEL MODEL YEAR PAK FILE NAME NEW TCM PART NUMBER OLD TCM PART NUMBERS DECRYPTION KEYWORD NEW CID NUMBER
WRX 2.0L DIT 2015 30919AD792.pak 30919AD792 30919AD790, 791 97ABDBFA L9FDD081
2016 30919AE551.pak 30919AE551 30919AE550 11D4093E K1FDD080

SERVICE PROCEDURE/INFORMATION

Step 1: 

Reprogram the TCM using the SSMIV following the normal FlashWrite procedure.

NOTE: SOA now highly recommends connecting the Midtronics GR8 Diagnostic Battery Charger to the vehicle and utilizing the Power Supply Mode feature anytime a vehicle control module is being reprogrammed. Once the GR8 is connected to the vehicle, as long as the battery is fully charged, it takes less than 3 minutes to boot-up the charger, select the Power Supply Mode, and have the battery voltage stabilized and ready for reprogramming.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.