2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Front Wheel Speed Sensor: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the bulkhead harness connector from TCM. < Ref. to REMOVALΒ , Transmission Control Module (TCM). >
  2. Set the ST between the TCM and bulkhead harness.

    ST 18460AA040 CHECK BOARD

  3. Set the probe of oscilloscope to the check board connector.

    Terminals:Β 

    No. 12 (+) - No. 26 (-)Β 

    Fig 1: Identifying Check Board Connector Terminals
    G10293212Courtesy of SUBARU OF AMERICA, INC.
  4. Lift up the vehicle and raise the vehicle speed up to 20 km/h (12 MPH).
  5. Check the waveform of front wheel speed sensor when vehicle speed is at 20 km/h (12 MPH).
    NOTE: The waveform cycle changes as the speed changes.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.