2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Extension Case: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the dust cover from extension case.
  2. Remove the snap ring using the ST and press.
    CAUTION: If the operation is performed with the dust cover installed, place a table between the extension case and the press table.

    ST 18762AA001 COMPRESSOR SPECIAL TOOL

    Fig 1: Removing Snap Ring Using Compressor Special Tool ST18762AA001
    G10268214Courtesy of SUBARU OF AMERICA, INC.
  3. Supply compressed air to remove the transfer clutch piston.
    Fig 2: Locating Transfer Clutch Piston
    G10268215Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the D-ring and O-ring from the transfer clutch piston.
  5. Remove the extension case oil seal from the extension case.
  6. Remove the plug from the extension case.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.