2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Automatic Transmission Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Attach the ST to converter case.

    ST 498277200 STOPPER SET

    Fig 1: Attaching ST To Converter Case
    G09480213Courtesy of SUBARU OF AMERICA, INC.
  2. When completely overhauling the transmission, refill approx. 10 L (2.6 US qt, 8.8 Imp qt) of CVTF through the transmission right side plug, and install the plug.
    CAUTION: Always use specified CVTF. Using other fluid will cause malfunction. < Ref. to HYDRAULIC CONTROL AND LUBRICATIONΒ , SPECIFICATION, General Description. >
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.