Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Information
On Service Menu, click "System Information" to display the following items.
- Product Information
On the System Information menu, click "Product Information" to display the following items.
- Product Information: Displays the product number of the main unit.
- Connectivity ID: ID that is required upon using the STARLINK functions. When this ID is not indicated, the STARLINK functions are not accessible.
- Version Information
On the System Information menu, click "Version Information" to display the version information of the following items.
- MSOC
- V-CPU
- MAP (only for models with navigation)
- SXM_SW
- RAD_SW
- CID
- DSP_FW
- DECK
CAUTION:It takes approximately 60 seconds after activation until the version information of the radio software (RAD_SW) is displayed.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.