Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
VDC OFF Switch: Inspection
- Remove the VDC OFF switch. < Ref. to REMOVALΒ , VDC OFF Switch. >
- Measure the resistance between the VDC OFF switch terminals.
Preparation tool:Β
Circuit testerΒ
Terminal No. Inspection conditions Standard 5 - 6 Switch OFF 1 MΞ© or more Switch ON Less than 1 Ξ© NOTE: Replace the VDC OFF switch if the inspection result is not within the standard value. - Install the VDC OFF switch. < Ref. to REMOVALΒ , VDC OFF Switch. >
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.