Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Cruise Control Command Switch: Installation
CAUTION:
- Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". < Ref. to CAUTION , General Description. >
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- Make sure that the steering roll connector is not turned from the original position.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. < Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). >
- Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
- Install the cruise control command switch assembly.
- Align the center position of the steering roll connector. < Ref. to ADJUSTMENT , Roll Connector. >
- Install the steering wheel.
Tightening torque:Β
39 N.m (4.0 kgf-m, 28.8 ft-lb)Β
Clearance:Β
Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)Β
- Install the driver's airbag module. < Ref. to INSTALLATION , Driver's Airbag Module. >
- Connect the battery ground terminal. < Ref. to
BATTERY
, NOTE, Note. >NOTE: For models other than STI model, connect the ground terminal to battery sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
