Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE
Keyless Access Control Module: Installation
NOTE:
Make sure that there are no differences from the contents of the current settings after installation. < Ref. to
LIST
, Read Current Data. >
- Install the reinforcement - combination meter and keyless access control module.NOTE: For model with navigation, install the GPS antenna assembly. < Ref. to INSTALLATION , GPS Antenna. >
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the combination meter assembly. < Ref. to INSTALLATION , Combination Meter. >
- Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.