2016 Subaru Forester 2.0XT PremiumFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

  1. Shift the select lever to "N" range.
  2. Disconnect the ground cable from battery.
  3. Lift up the vehicle.
  4. Remove the center exhaust pipe. (Non-turbo model) Ref. to EXHAUST(H4DO) > Center Exhaust Pipe > Β REMOVALΒ  .
  5. Remove the center exhaust pipe (rear). (Turbo model) Ref. to EXHAUST(H4DOTC) > Center Exhaust Pipe >Β REMOVALΒ  .
  6. Remove the center exhaust cover.
    Fig 1: Locating Center Exhaust Cover
    G09481150Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the snap pin and washer from the shifter arm.
    Fig 2: Identifying Shifter Arm, Select Cable, Washer And Snap Pin
    G10406073Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from the transmission case.
    Fig 3: Identifying Select Cable And Plate Assembly
    G10406074Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the cable from arm COMPL.
    Fig 4: Identifying Adjusting Nut And Arm COMPL
    G10406075Courtesy of SUBARU OF AMERICA, INC.
  10. Raise the claw of clamp to remove the cable from bracket.
    Fig 5: Identifying Cable Claw Of Clamp
    G10406076Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.