2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE

Symptom Table

Steering (mechanical factors) symptom table

STEERING (MECHANICAL FACTORS) SYMPTOM TABLE

Symptoms Inspection items Reference
Steering operation is heavy Front tires (improperly inflated, uneven wear) WHEEL AND TIRE SYSTEM
Front wheel alignment (improper) FRONT WHEEL ALIGNMENT
Front suspension (lower ball joint) INSPECTION
Steering column assembly UNIT INSPECTION 
Steering gear assembly INSPECTION
Power steering computer power supply voltage CIRCUIT FIGURE
Power steering computer assembly POWER STEERING COMPUTER
The presence of continued operation under high load or dry steering -
Poor steering wheel return to center Front tires (improperly inflated, uneven wear) WHEEL AND TIRE SYSTEM
Front wheel alignment (improper) FRONT WHEEL ALIGNMENT
Steering column assembly UNIT INSPECTION 
Steering gear assembly INSPECTION
Power steering computer assembly POWER STEERING COMPUTER
Steering exhibits no or excess play Steering intermediate shaft assembly No. 2 UNIT INSPECTION 
Steering column assembly UNIT INSPECTION 
There is a thumping noise during power steering operation, when the steering wheel returns to the neutral position Steering intermediate shaft assembly No. 2 UNIT INSPECTION 
Front suspension (lower ball joint) INSPECTION
Front axle hub (hub bearing) INSTALLATION
Steering gear assembly INSPECTION
There is a rubbing sound when the steering wheel is turned during slow driving Steering column assembly REMOVAL 
Steering roll connector INSPECTION
Rubbing of the steering wheel and the column cover INSTALLATION 
An abnormal high-pitched squeaking sound occurs when the steering wheel is slowly turned when the vehicle is stopped Steering column assembly INSTALLATION 
Steering wheel installation condition INSTALLATION 
The steering wheel vibrates (accompanied with a noise) during dry steering Steering column assembly INSTALLATION 
Steering wheel installation condition INSTALLATION 
P/S warning light remains ON Refer to the flow chart P/S WARNING LIGHT REMAINS ON
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.