Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE
Steering Lock System: Precautions
- Precautions when checking diagnosis codes
- As the steering lock actuator assembly (Steering lock ECM) does not store past diagnostics, when diagnosis codes are output, do not turn the ignition to IG OFF or perform any deletions until diagnosis code checking and recording is completely finished.
- Precautions when attaching/detaching the battery ground terminal or during a battery voltage drop
- After attaching/detaching the battery ground terminal or when there is a drop in battery voltage, after the battery issue has been resolved you may not be able to release the steering lock or start the engine unless you first open and close the driver's door while the ignition is in the IG OFF state.
- Precautions when replacing the steering lock actuator assembly (Steering lock ECM)
- After replacing the steering lock actuator assembly (Steering lock ECM), before starting the engine be sure to turn the steering mechanism to the left and right to confirm that the steering is not locked. If the steering is locked, perform the lock procedure and unlock it again. This will prevent the engine from being started while the steering lock is on.
- Precautions when replacing the ECM
- When replacing any of the following parts, please refer to the "Registration manual for immobilizer".
- Smart key computer assembly (Collation ECM)
- Steering lock actuator assembly (Steering lock ECM)
- Engine control computer
- Electrical key transmitter sub-assembly (Electronic key)
- ID code box (with ID code box)
- When replacing any of the following parts, please refer to the "Registration manual for immobilizer".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
