Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE
Steering Column Assembly: Assembly
- Install the steering lock assembly (With smart entry)
- Secure the steering column assembly in a vise between aluminum plates.CAUTION: Do not close the vise too strongly.
- Attach the steering lock actuator assembly with a new steering lock set bolt and it until the bolt head is wrenched off.
- Secure the steering column assembly in a vise between aluminum plates.
- Installation of the unlock warning switch assembly (without smart entry)
- Engage the two tabs and install the unlock warning switch assembly onto the steering column upper bracket.NOTE: Install the unlock warning switch assembly by sliding it in the direction indicated by the arrows in the diagram.
- Engage the two tabs and install the unlock warning switch assembly onto the steering column upper bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
