Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Subaru BRZ Series.HyperBlueFACTORY OEM SERVICE PROCEDURE
Enabling Conditions
| Overlap prohibited DTC | None |
| Battery voltage | 10.9V or more |
| Sub-feedback | In operation |
| Intake air amount | 10 g/s (0.35 oz/s) or more |
| Estimated temperature for rear oxygen sensor element | 450°C (842°F) or more |
| Air fuel ratio subtracted from the target air fuel ratio of the executing condition with interrupt control | Value of map |
| Duration while rear oxygen sensor output voltage is less than 0.55 V | 10 seconds or more |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.